Month: February 2023

Posted on by

Unfortunate Postage News

While doing a test packaging and postage estimate for a customer last night, I discovered that the post office has pulled the proverbial rug out from under us and discontinued the regional priority flat rate shipping option. This means that the wonderful regional rates that I have been able to pass along to customers in the form of postage refunds will be no more. Yep. Well, poo!

Picture of mailing boxes and carving material pieces.
Flat Rate Mailers

The shipping cost listed on Stampeaz.com is not the full retail priority mail price, as I get a small commercial discount which I pass along. I will still do my best to optimize shipping costs by packing as economically as I can – this is especially relevant to orders of multiple large pieces, since the postage calculator doesn’t know how to take my awesome packing skills into account and can overestimate the type and number of boxes or envelopes required.

Also, as you can see in the photo above, I still have some bits and bobs to share as I wrap and label orders, so be sure to let me know if you’d like me to include some in your package. There are little pieces of PZ Kut, OZ Kut, Tan-Z Kut, Firm Kut and some experimental pieces from ages ago that didn’t make it to an actual production run. 🙂

Posted on by — 6 Comments

But I Already Carved

A number of people asked about sanding images they had already carved in order to get better ink coverage. There are a couple of approaches that can be taken to improve how the block takes ink if it didn’t get sanded before carving.

The simplest method is to take a solvent based permanent ink like StazOn and cover the surface of the carving material with it and leave it to dry completely.

Sandpaper and carved block on a flat surface.
Sanding a Carved Block

If the simple inking option doesn’t do the trick and there is still an inking problem, try taking a very fine sandpaper (the sheet above is 600 grit) and putting it grit side up on a very flat surface.

Gently sanding a carved block.
Sanding a Carved Image

Then, keeping the block flat against the sanding surface, gently run the face of the carving around the sandpaper a few times. Make sure the surface is flat and check often to make sure it’s coming off evenly. Remember, not much needs to be removed – just the barest bit off the top to remove the extrusion residue. Also, be careful not to press too hard in any single spot, since the block is flexible and it’s possible to end up with uneven bits where fingers pressed the block into the sandpaper.

Some carvers also use the little manicure blocks that have grit on them. And, if the carving is particularly intricate and likely to wear away rapidly, holding a small piece of sandpaper in your fingers and very, very gently touching up the block’s surface can also work. Be particularly careful with this approach, as it’s easy to accidentally take an edge down too far, but if ink isn’t adhering to the block well enough to get a good print, it’s probably worth the risk.

I hope this helps a little – and feel free to ask questions! After all, that will help me know what might be useful to talk about here on this blog.

Also, it’s the anniversary of the day I began running Stampeaz many long years ago. So, I’m celebrating with 10% off Tan-Z Kut today. If you place an order, don’t forget to ask for some of the bits and bobs I mentioned in a previous blog post – I still have some to share, if you want.